Engine Power Packages

289 / 325 Horsepower Carbureted Engine

  • Blueprinted machined 289  Block

  • Nodular Cast Iron Crankshaft, deburred and Micropolished

  • Hyperuetectic 9.5 to 1 Federal Mogul Pistons

  • Sealed Power Moly Rings

  • Heavy Duty Double Roller Dynagear Timing Set

  • Hydraulic Roller s Comp Cams Camshaft Power Range (2000 to 6000 RPM)

  • Federal Mogul Bearings

  • New Aluminum 60cc cylinder heads with Large valves & HD Springs

  • New Hardened Pushrods

  • Comp Cams Magnum 1.6 to 1 ratio Roller Rockers

  • Melling High Volume Oil pump

  • Complete Fel-pro Gasket set

  • Factory Replacement Harmonic Balancer

  • New Flexplate for Automatic Trans. (Std. Extra)

  • Oil pan, Timing cover and Chrome Valve Covers

  • Edelbrock 650 cfm 4 barrel Carburetor with electric choke

  • Edelbrock Performer Dual Plane Intake Manifold

  • New high flow Water pump and Fuel Pump

  • Pertronix Flamethrower Electronic Distributor with 45,000 volt Coil

  • New Spark plugs and 8mm Silicone Wires

  • New Thermostat Housing

  • Chrome Air Cleaner

  • PCV Ventilation System

  • New Braided  Steel Fuel Lines and Gas Filter

  • Ignition Timing Set, Carburetor fully adjusted

  • Hot Run tested and dialed in

  • Video Footage taken with your engine running in our test Stand

  • Packaged and Crated

  • Installation Video Included





 High Flow GTP Ford Cast Iron Heads  (No longer available)

Polished Aluminum Billet March Pulleys, Brackets, V-Belt, 100 amp Chrome Alternator installed and adjusted  - $795.00  Serpentine Setup - $850.00




Click here for any Monthly Special Offers